When the System Does Not Seem to Work Properly
The following messages may be displayed on the DIC:
SERVICE PARK ASSIST: If this message occurs, take the vehicle to your dealer to repair the system.
PARK ASST BLOCKED SEE OWNERS MANUAL: This message can occur under the following conditions:
• The ultrasonic sensors are not clean. Keep the vehicle's rear bumper free of mud, dirt, snow, ice, and slush. For cleaning instructions, see Exterior Care on page 10‑102.
• The park assist sensors are covered by frost or ice. Frost or ice can form around and behind the sensors and may not always be seen; this can occur after washing the vehicle in cold weather. The message may not clear until the frost or ice has melted.
• A trailer was attached to the vehicle, or an object was hanging out of the tailgate during the last drive cycle. Once the object is removed and the tailgate is raised, URPA will return to normal operation.
• A tow bar is attached to the vehicle.
• The bumper is damaged. Take the vehicle to your dealer to repair the system.
• Other conditions, such as vibrations from a jackhammer or the compression of air brakes on a very large truck, are affecting system performance.
See also:
Disarming the System
To disarm the system, do one of the following:
○ Press on the RKE transmitter.
○ Turn the ignition to ON/RUN.
○ Allow the alarm to time out after about 30 seconds and reset itsel ...
Compass Zone
The zone is set to zone eight upon leaving the factory. Your dealer will set the correct zone for your location.
Under certain circumstances, such as during a long-distance, cross-country trip or mov ...
Conditions in Which Remote Start Will Not Work
The remote vehicle start feature will not operate if:
○ The key is in the ignition.
○ The hood or doors are not closed.
○ The hazard warning flashers are on.
○ There is an ...