Voice Pass-Thru
Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature.
To access contacts stored in the cell phone:
1. Press and hold 
for two seconds.
2. Say “Bluetooth.” This command can be skipped.
3. Say “Voice.” The system responds “OK, accessing <phone name>.” The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.
See also:
Hazard Warning Flashers
Hazard Warning Flasher:
Press this button located on the instrument panel below the audio system, to make the front and rear turn signal lamps flash on and off.
This warns others that you are hav ...
If a Tire Goes Flat
It is unusual for a tire to blow out while driving, especially if the tires are maintained properly. See Tires on page 10‑37. If air goes out of a tire, it is much more likely to leak out slowly ...
High-Beam On Light
The high-beam on light comes on when the high-beam headlamps are in use.
See Headlamp High/Low-Beam Changer on page 6‑2 for more information. ...