Using the “Digit Dial” Command
The digit dial command allows a phone number to be dialed by entering the digits one at a time.
After each digit is entered, the system repeats back the digit it heard followed by a tone.
If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.
To hear all of the numbers recognized by the system, say “Verify” at any time.
1. Press and hold for two seconds.
2. Say “Digit Dial.” 3. Say each digit, one at a time, that you want to dial. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say “Dial.” Once connected, the person called will be heard through the audio speakers.
See also:
Place a Call Using a Stored Number
1. Push . System responds:
“OnStar ready.” 2. Say “Call <name tag>.” System responds: “OK, calling <name tag>.” ...
What to Do with Used Oil
Used engine oil contains certain elements that can be unhealthy for your skin
and could even cause cancer. Do not let used oil stay on your skin for very long.
Clean your skin and nails with soap ...
Underbody Maintenance
Use plain water to flush dirt and debris from the vehicle's underbody. Your dealer
or an underbody car washing system can do this. If not removed, rust and corrosion
can develop. ...