Using the “Digit Store” Command

GMC Sierra / GMC Sierra Owners Manuals / Infotainment System / Phone / Bluetooth / Using the “Digit Store” Command

If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.

To hear all of the numbers recognized by the system, say “Verify” at any time.

1. Press and hold 2. Say “Digit Store.” 3. Say each digit, one at a time, that you want to store. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say “Store,” and then follow the directions given by the system to save a name tag for this number. for two seconds.

2. Say “Digit Store.” 3. Say each digit, one at a time, that you want to store. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say “Store,” and then follow the directions given by the system to save a name tag for this number.

    See also:

    Towing the Vehicle
    Notice: To avoid damage, the disabled vehicle should be towed with all four wheels off the ground. Care must be taken with vehicles that have low ground clearance and/or special equipment. Always ...

    Bulb Replacement
    For the proper type of replacement bulbs, see Replacement Bulbs on page 10‑37. For any bulb changing procedure not listed in this section, contact your dealer. ...

    Emergency
    With Automatic Crash Response, the built-in system can automatically connect to help in a crash even if you cannot ask for it. Push to connect to an Emergency Advisor. GPS technology is used to iden ...