Starting the Vehicle
1. Press and release 
on the Remote
Keyless Entry transmitter.
2. Press and hold 
for about two
seconds. The turn signal lamps will briefly flash to confirm the vehicle has been
started. The parking lamps will turn on and remain on as long as the engine is running.
The vehicle's doors will be locked.
3. The key must be inserted and turned to ON/RUN before driving.
The engine will shut off after 10 minutes unless a time extension is done or the key is inserted and turned to ON/RUN.
See also:
Erasing Universal Remote Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote device:
1. Press and hold down the two outside buttons u ...
Cigarette Lighter
To use the cigarette lighter, push it in all the way, and let go. When it is ready for use, the lighter pops back out.
Notice: Holding a cigarette lighter in while it is heating does not let the ligh ...
Programming the Universal Home Remote System
For questions or help programming the Universal Home Remote System, call 1-800-355-3515 or go to www.homelink.com.
Programming a garage door opener involves time-sensitive actions, so read the entire ...