Rear Seats (Extended Cab Full Bench)
Folding the Rear Seat
Notice: Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts and return them to their normal stowed position before folding a rear seat.
To fold the seat:
1. Pull up on the front of the seat cushion while pulling down on the release strap under the seat cushion.
2. Pull the seat cushion up until it latches with the seatback.
3. Pull forward on the seat cushion to make sure it is locked in place.
To unfold the seat:
1. Push the seat cushion rearward while pulling the release strap under the seat cushion. Pull the seat cushion down until it latches.
2. Pull up on the seat cushion to make sure it is locked in place.
Make sure the safety belts are not twisted or caught in the seat cushion.
WARNING
A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted.
See also:
Ride & Handling
Whenever I approach a vehicle this large I bring along the expectation that
it will be hard to maneuver. In the Yukon I was surprisingly sure of myself,
even on the tightest city streets. Not only ...
RVC Location
The camera is located in the bezel for the tailgate handle.
This shows the field of view that the camera provides.
A. View displayed by the camera
A. View displayed by the camera
B. Corners ...
Center Dome Lamps
There are front and rear dome lamps.
The dome lamp controls are located in the overhead console. To change the settings,
press the following:
: Turns the lamp off, even when a
door is open.
: ...