Testing the Alarm
To test the alarm:
1. Lower the driver window and open the driver door.
2. Press lock on the RKE transmitter.
3. Close the door and wait for the security light to go out.
4. Reach in through the window, unlock the door with the manual door lock, and open the door.
This should set off the alarm.
If the alarm does not sound when it should but the headlamps flash, check to see if the horn works. The horn fuse may be blown. To replace the fuse, see Fuses and Circuit Breakers on page 10‑47.
If the alarm does not sound or the headlamps do not flash, see your dealer for service.
See also:
Regular Cab Models
1. If the child restraint manufacturer recommends that the top tether be attached, attach and tighten the top tether to the top tether anchor, if your vehicle has one.
Refer to the child restraint in ...
Windshield Wiper/Washer
The front wiper control is located on the turn and lane-change lever.
The windshield wipers are controlled by turning the band with
on it.
(Mist): For
a single wipe, turn to , then
release ...
Overheated Engine Protection Operating Mode
If an overheated engine condition exists and the ENGINE POWER IS REDUCED message displays, an overheat protection mode which alternates firing groups of cylinders helps to prevent engine damage. In th ...