License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate trim.
2. Turn and pull the license plate lamp forward through the liftgate trim opening.
3. Turn the bulb socket counterclockwise and pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license plate lamp.
See also:
Armrest Retaining Strap
WARNING
A rear center armrest that is not properly stowed and secured could fall forward
during a sudden stop or collision. The armrest could contact an infant secured in
a rear&-facing child ...
Environmental Concerns
• Always use established trails, roads, and areas that have been set aside for public off-road recreational driving and obey all posted regulations.
• Do not damage shrubs, flowers, trees, or gra ...
Electronic Range Select (ERS) Mode
ERS or manual mode allows for the selection of the range of gear positions. Use
this mode when driving down hill or towing a trailer to limit the top gear and vehicle
speed.
To use this feature:
...