Electric Trailer Brake Control Wiring Provisions
These wiring provisions for an electric trailer brake controller are included with the vehicle as part of the trailer wiring package.
The instrument panel contains blunt cut wires behind the steering column for the electric trailer brake controller. The harness contains the following wires:
• Red/Black: Power Supply
• White: Brake Switch Signal
• Gray: Illumination
• Dark Blue: Trailer Brake Signal
• Black: Ground
The electric trailer brake controller should be installed by your dealer or a qualified service center.
See also:
Leaving the Vehicle With the Engine Running
WARNING
It can be dangerous to leave the vehicle with the engine running.
The vehicle could move suddenly if the shift lever is not fully in P (Park) with the parking brake firmly set.
If you have ...
Turning the Rear Vision Camera System On or Off
To turn the rear vision camera system on or off:
1. Shift into P (Park).
2. Press the MENU button to enter the configure menu options, then press the MENU hard key to select Display or touch the Dis ...
Add-On Electrical Equipment
Notice: Do not add anything electrical to the vehicle unless you check with your dealer first.
Some electrical equipment can damage the vehicle and the damage would not be covered by the vehicle's wa ...