Trailer Wiring Harness
Basic Trailer Wiring
The trailer wiring harness, with a seven-pin connector, is located at the rear of the vehicle and is tied to the vehicle's frame. The harness connector can be plugged into a seven-pin universal heavy-duty trailer connector available through your dealer.
The seven-wire harness contains the following trailer circuits:
• Yellow: Left Stop/Turn Signal
• Dark Green: Right Stop/Turn Signal
• Brown: Taillamps
• Black: Ground
• Light Green: Back-up Lamps
• Red/Black: Battery Feed
• Dark Blue: Trailer Brake*
*The fuse for this circuit is installed in the underhood electrical center, but the wires are not connected.
They should be connected by your dealer or a qualified service center.
If the back-up lamp circuit is not functional, contact your dealer.
If a remote (non-vehicle) battery is being charged, press the Tow/Haul mode switch located on the center console near the climate controls.
This will boost the vehicle system voltage and properly charge the battery. If the trailer is too light for Tow/Haul mode, turn on the headlamps (non-HID only) as a second way to boost the vehicle system and charge the battery.
See also:
Under the Hood
GM's two-mode hybrid system enables "full" hybrid operation with the
capability to cruise on electric power up to 30 mph. The gas engine kicks in if
more acceleration is needed, as well ...
How to Wear Safety Belts Properly
This section is only for people of adult size.
There are special things to know about safety belts and children. And there are
different rules for smaller children and infants. If a child will be r ...
Airbag System Messages
SERVICE AIR BAG
This message displays if there is a problem with the airbag system.
Have your dealer inspect the system for problems. See Airbag Readiness Light on page 5‑16 and Airbag System ...





