Resuming a Set Speed
If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory.
Once the vehicle speed is 40 km/h (25 mph) or greater, press the +RES button on the steering wheel.
The vehicle returns to the previously set speed and stays there.
See also:
Turn Signals When Towing a Trailer
The turn signal indicators on the instrument panel flash whenever signaling a
turn or lane change. Properly hooked up, the trailer lamps also flash, telling other
drivers the vehicle is turning, c ...
Lower Anchors and Tethers for Children
(LATCH System)
The LATCH system holds a child restraint during driving or in a crash.
This system is designed to make installation of a child restraint easier.
The LATCH system uses anchors in the vehicle and atta ...
Canceling a Remote Start
To cancel a remote start, do one of the following:
○ Press until the parking lamps
turn off.
○ Turn on the hazard warning flashers.
○ Insert the key and turn it to ON/ RUN and ...