Parking Brake

To set the parking brake, hold the regular brake pedal down, then push the parking brake pedal down.

To set the parking brake, hold the regular brake pedal down, then push the parking brake pedal down.

If the ignition is on, the brake system warning light will come on.

See Brake System Warning Light on page 5‑21.

Notice: Driving with the parking brake on can overheat the brake system and cause premature wear or damage to brake system parts. Make sure that the parking brake is fully released and the brake warning light is off before driving.

To release the parking brake, hold the regular brake pedal down, then push down momentarily on the parking brake pedal until you feel the pedal release. Slowly pull your foot up off the park brake pedal.

If the parking brake is not released when you begin to drive, the brake system warning light will be on and a chime will sound warning you that the parking brake is still on.

If you are towing a trailer and are parking on a hill, see Driving Characteristics and Towing Tips on page 9‑45.

    See also:

    Ultrasonic Parking Assist
    If available, Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). It operates at speeds less than 8 km/h ...

    Fuel E85 (85% Ethanol)
    Vehicles that have a FlexFuel badge and a yellow fuel cap can use either unleaded gasoline or ethanol fuel containing up to 85% ethanol (E85). See Fuel E85 (85% Ethanol) on page 9‑76. For all o ...

    Turn-by-Turn Navigation
    1. Push to connect to a live Advisor. 2. Request directions. 3. Directions are downloaded to the vehicle. 4. Follow the voice-guided commands. ...