Voice Pass-Thru

Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature.

To access contacts stored in the cell phone:

1. Press and hold 2. Say “Bluetooth.” This command can be skipped. for two seconds.

2. Say “Bluetooth.” This command can be skipped.

3. Say “Voice.” The system responds “OK, accessing <phone name>.” The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.

    See also:

    Door Ajar Messages
    DRIVER DOOR OPEN This message displays and a chime may sound if the driver door is not fully closed and the vehicle is shifted out of P (Park). Stop and turn off the vehicle, check the door for obstr ...

    Dome Lamps
    There are front and rear dome lamps. The dome lamp controls are located in the overhead console. To change the settings, press the following: (Dome Lamp Override): Turns the lamps off, even whe ...

    Battery Voltage and Charging Messages
    BATTERY SAVER ACTIVE This message displays when the vehicle has detected that the battery voltage is dropping beyond a reasonable point. The battery saver system starts reducing certain features ...