Making a Call
Calls can be made using the following commands.
Dial or Call: The dial or call command can be used interchangeably to dial a phone number or a stored name tag.
Digit Dial: This command allows a phone number to be dialed by entering the digits one at a time.
Re-dial: This command is used to dial the last number used on the cell phone.
See also:
Extended Cab
On vehicles with a sunroof, the sunroof only operates when the ignition is in the ACC/ACCESSORY or ON/RUN or the Retained Accessory Power (RAP) is active.
See Retained Accessory Power (RAP) on page ...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
If the level is below the bottom of the fill plug hole, located on the transfer
case, the vehicle will need some lubricant ad ...
Place a Call Using a Stored Number
1. Push . System responds:
“OnStar ready.” 2. Say “Call <name tag>.” System responds: “OK, calling <name tag>.” ...