Playing a CD
Insert a CD partway into the slot, label side up. The player pulls it in and the CD should begin playing.
EJECT: Press and release to eject the disc that is currently playing. A beep sounds and Ejecting Disc displays. Once the disc is ejected, Remove Disc displays. The disc can be removed.
If the disc is not removed, after several seconds, the disc automatically pulls back into the player.
(Tune): Turn to select tracks on the CD that is currently playing.
SEEK or
SEEK: Press
SEEK to go to the start of the current track, if more than 10 seconds on the CD have played.
Press SEEK to go to the next track.
If either arrow is held, or pressed multiple times, the player continues moving backward or forward through the tracks on the CD.
REV (Fast Reverse): Press and hold to reverse playback quickly within a track. Sound will be heard at a reduced volume. Release to resume playing the track. The elapsed time of the track displays.
FWD (Fast Forward): Press and hold to advance playback quickly within a track. Sound will be heard at a reduced volume.
Release to resume playing the track. The elapsed time of the track displays.
RDM (Random): CD tracks can be listened to in random, rather than sequential order with the random setting. To use random, press the softkey under the RDM label until Random Current Disc displays.
Press the softkey again to turn off random play.
BAND: Press to listen to the radio when a CD is playing. The CD remains inside the radio for future listening.
CD/AUX (CD/Auxiliary): Press to select between CD, or Auxiliary.
• When a CD is in the player, the CD icon and a message showing the disc and/or track number display.
• If an auxiliary input device is not connected, “No Input Device Found” displays.
See also:
Ignition Transmission Lock Check
While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
• The ignition should turn to LOCK/OFF only when the shift lever is in P (Park).
...
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.
See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...
Exterior Lamp Controls
The exterior lamps control is located on the instrument panel to the left of the steering wheel.
It controls the following systems:
• Headlamps
• Taillamps
• Parking Lamps
• License Pla ...