Finding a Station

BAND: Press to switch between AM, FM, or XM. The selection displays.

SEEK and (Tune): Turn to select radio stations.

SEEK: Press to go to the previous or next station and stay there. SEEK and SEEK: Press to go to the previous or next station and stay there. SEEK: Press to go to the previous or next station and stay there.

To scan stations, press and hold until a beep sounds. or until a beep sounds. until a beep sounds.

The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again to stop scanning.

The radio only seeks and scans stations with a strong signal that are in the selected band.

    See also:

    New Vehicle Break-In
    Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: ○ Do not drive at any one constant speed, fast or slow, for ...

    If a Tire Goes Flat
    It is unusual for a tire to blow out while driving, especially if the tires are maintained properly. If air goes out of a tire, it is much more likely to leak out slowly. But if there ever is a bl ...

    Universal Remote System
    See Radio Frequency Statement on page 13‑22 for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...