Finding a Station

BAND: Press to switch between AM, FM, or XM. The selection displays.

SEEK and (Tune): Turn to select radio stations.

SEEK: Press to go to the previous or next station and stay there. SEEK and SEEK: Press to go to the previous or next station and stay there. SEEK: Press to go to the previous or next station and stay there.

To scan stations, press and hold until a beep sounds. or until a beep sounds. until a beep sounds.

The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again to stop scanning.

The radio only seeks and scans stations with a strong signal that are in the selected band.

    See also:

    Before Driving Off-Road
    ○ Have all necessary maintenance and service work completed. ○ Fuel the vehicle, fill fluid levels, and check inflation pressure in all tires, including the spare, if equipped. ○ ...

    Turn and Lane-Change Signals
    An arrow on the instrument panel cluster will flash in the direction of the turn or lane change. Move the lever all the way up or down to signal a turn. Raise or lower the lever until the arrow ...

    Engine Power Messages
    ENGINE POWER IS REDUCED This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode. See Engine Overhea ...