Driver Information Center (DIC) (Without DIC Buttons)
If your vehicle does not have DIC buttons, the information below explains the operation of this system.
The DIC has different displays which can be accessed by pressing the trip odometer reset stem located on the instrument panel cluster. Pressing the trip odometer reset stem will also turn off, or acknowledge, DIC messages.
The DIC displays trip and vehicle system information, and warning messages if a system problem is detected.
If your vehicle does not have DIC buttons, you can use the trip odometer reset stem to view the following displays: odometer, trip odometers, oil life, park assist menu for vehicles with the Ultrasonic Rear Parking Assist (URPA) system, units, and display language.
If your vehicle has DIC buttons, you can use the trip odometer reset stem to view the following displays:
odometer and trip odometers.
See also:
Remote Vehicle Start
The vehicle may have this feature that allows you to start the engine from outside
the vehicle.
(Remote Vehicle Start): This button
will be on the RKE transmitter if the vehicle has remote start. ...
Turn and Lane-Change Signals
An arrow on the instrument panel cluster will flash in the direction of the turn
or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow ...
Using the “Re-dial” Command
1. Press and hold for two seconds.
2. After the tone, say “Re-dial.” Once connected, the person called will be heard through the audio speakers. ...