Antilock Brake System (ABS) Warning Light
The ABS warning light comes on briefly when the ignition key is turned to ON/RUN. This is normal.
If the light does not come on then, have it fixed so it will be ready to warn you if there is a problem.
If the light stays on, turn the ignition to LOCK/OFF. If the light comes on while driving, stop as soon as possible and turn the ignition off.
Then start the engine again to reset the system. If the light still stays on, or comes on again while driving, the vehicle needs service. If the regular brake system warning light is not on, there are still brakes, but no antilock brakes. If the regular brake system warning light is also on, there are no antilock brakes and there is a problem with the regular brakes. See Brake System Warning Light on page 5‑21.
See also:
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
To replace one of these bulbs:
1. Open the tailgate. See Tailgate on page 2‑10 for more information.
2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull ...
Cellular and GPS Antennas
Avoid placing items over or near the antenna to prevent blocking cellular and
GPS signal reception. Cellular reception is required for OnStar to send remote signals
to the vehicle. ...
Care of Safety Belts
Keep belts clean and dry.
WARNING
Do not bleach or dye safety belts.
It may severely weaken them. In a crash, they might not be able to provide adequate protection.
Clean safety belts only with mi ...