Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.
See “Compass Variance (Zone) Procedure” earlier in this section.
Do not operate any switches such as window, sunroof, climate controls, seats, etc.
during the calibration procedure.
2. Press the vehicle information button until PRESS
TO CALIBRATE COMPASS displays.
3. Press the set/reset button to start the compass calibration.
4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete. The DIC display will then return to the previous menu.
See also:
Passing
More passing distance is needed when towing a trailer. Because the rig is longer,
it is necessary to go farther beyond the passed vehicle before returning to the
lane. ...
How to Add Automatic Transmission Fluid
Refer to Recommended Fluids and Lubricants on page 11‑12 to determine what kind of transmission fluid to use.
Using a funnel, add fluid down the transmission dipstick tube only after checking t ...
Leaving After Parking on a Hill
1. Apply and hold the brake pedal while you:
1.1. Start the engine.
1.2. Shift into a gear.
1.3. Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is clea ...





