What Makes an Airbag Inflate?
In a deployment event, the sensing system sends an electrical signal triggering a release of gas from the inflator. Gas from the inflator fills the airbag causing the bag to break out of the cover. The inflator, the airbag, and related hardware are all part of the airbag module.
For airbag location, see Where Are the Airbags? on page 3‑26.
See also:
When to Check and Change Automatic Transmission Fluid
It is usually not necessary to check the transmission fluid level.
The only reason for fluid loss is a transmission leak or overheated transmission. If a small leak is suspected, then use the followi ...
Battery Replacement
To change the remote control batteries, do the following:
1. Slide the rear cover back on the remote control.
2. Replace the two batteries in the compartment. Make sure they are installed correctly ...
Using the 3.5mm (1/8 in) Auxiliary Input Jack
The auxiliary input jack is located on the lower right side of the faceplate.
This is not an audio output; do not plug a headphone set into the front auxiliary input jack. Connect an auxiliary input ...