Returning the Seat to the Seating Position
To return the seatback to the seating position:
1. From the rear of the vehicle, raise the seatback to the upright position using the pullstrap on the back of the third row seat, or lift the seatback and push it into place from inside the vehicle.
WARNING
If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there.
Always push and pull on the seatbacks to be sure they are locked.
2. Push and pull on the seatback to make sure it is locked in place.
WARNING
A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash.
The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted.
3. Reconnect the center safety belt mini-latch to the mini-buckle.
Do not let it twist.
4. Pull on the safety belt to be sure the mini-latch is secure.
See also:
Belts
• Belts may need replacing if they squeak or show signs of cracking or splitting.
• Trained dealer technicians can inspect the belts and recommend replacement when necessary. ...
Vehicle Load Limits
It is very important to know how much weight your vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo, and all nonfactory-installed opt ...
Unable to Connect to OnStar Message
If there is limited cellular coverage or the cellular network has reached maximum
capacity, this message may come on. Push Q to try the call again or try again after
driving a few miles into anoth ...