Back–Up Lamp

Removal of the lamp assembly is not required to replace the back-up lamp bulb.

To replace one of these lamps:

1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim access panel.

3. Turn the bulb socket counterclockwise and pull it out.

3. Turn the bulb socket counterclockwise and pull it out.
4. Pull the bulb straight out of the socket.
5. Install the new bulb.
6. Push the bulb socket in and turn it clockwise.
7. Reinstall the interior trim access panel.

    See also:

    Engine Oil Additives/Engine Oil Flushes
    Do not add anything to the oil. The recommended oils with the dexos specification and displaying the dexos certification mark are all that is needed for good performance and engine protection. Engine ...

    2008 GMC Yukon Review
    The 2007 GMC Yukon — along with the Cadillac Escalade and Chevrolet Tahoe — is one of three completely redesigned full-size SUVs from General Motors. I've driven all three, and with the except ...

    Recommended Transfer Case Settings
    Notice: Driving on clean, dry pavement in four-wheel drive for an extended period of time can cause premature wear on the vehicle's powertrain. Do not drive on clean, dry pavement in Four-Wheel Driv ...