Voice Pass-Thru

Voice pass&-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature.

To access contacts stored in the cell phone:

1. Press followed by a tone.. The system responds “Ready,” followed by a tone.
2. Say “Bluetooth.” This command can be skipped.
3. Say “Voice.” The system responds “OK, accessing <phone name>.”

The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.

    See also:

    Setting Preset Stations
    To store presets: 1. Tune to a radio station. 2. Press and hold one of the six numbered pushbuttons for three seconds until a beep sounds. 3. Repeat Steps 1 and 2 to store additional radio stations ...

    Engine Hours
    To display the ENGINE HOURS, place the ignition in LOCK/OFF or ACC/ACCESSORY, then press and hold the trip odometer reset stem for four seconds while viewing the ODOMETER. This display shows the total ...

    Emergency
    With Automatic Crash Response, the built-in system can automatically connect to help in a crash even if you cannot ask for it. Push to connect to an Emergency Advisor. GPS technology is used to iden ...