Power Liftgate 3/4 Mode
To program the liftgate opening height:
1. Turn the liftgate switch to either the MAX , or the 3/4 mode position and power open the liftgate.
2. Stop the liftgate movement at the desired height by pressing any liftgate switch. Manually adjust the liftgate position if required.
3. Press and hold the button on the liftgate adjacent to the latch until the turn signals flash and a beep sounds to indicate that the new setting is recorded.
When power opened with the 3/4 mode selected, the liftgate stops at the new set position.
If there is no audible and visual feedback when setting the intermediate stop position, the liftgate height is being set below the 3/4 open height minimum (approximately 1.5 m or 5 ft). The liftgate cannot be set below that minimum and the new setting will not be recorded.
See also:
Power Reclining Seatbacks
To adjust a power seatback, if available:
○ Tilt the top of the control rearward to recline.
○ Tilt the top of the control forward to raise. ...
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
To replace one of these bulbs:
1. Open the tailgate. See Tailgate on page 2‑10 for more information.
2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull ...
Trademarks and License Agreements
Manufactured under license under U.S. Patent #'s: 5,451,942; 5,956,674; 5,974,380; 5,978,762; 6,487,535 & other U.S. and worldwide patents issued & pending. DTS and the Symbol are registered ...