Starting the Engine Using Remote Start

To start the engine using the remote start feature:

1. Press and release transmitter. on the RKE transmitter.

2. Press and hold seconds. The turn signal lamps will briefly flash to confirm the vehicle has been for about two seconds. The turn signal lamps will briefly flash to confirm the vehicle has been started. The parking lamps will turn on and remain on as long as the engine is running. The vehicle's doors will be locked.

3. The key must be inserted and turned to ON/RUN before driving.

The engine will shut off after 10 minutes unless a time extension is done or the key is inserted and turned to ON/RUN.

    See also:

    Sunroof
    The ignition must be in ON/RUN or ACC/ACCESSORY to operate the sunroof and power sunshade. See Retained Accessory Power (RAP) on page 9‑20. The vehicle may have a sunroof over the front seats ...

    Airbag System Messages
    SERVICE AIR BAG This message displays if there is a problem with the airbag system. Have your dealer inspect the system for problems. See Airbag Readiness Light on page 5‑16 and Airbag System ...

    Call Waiting
    Call waiting must be supported on the cell phone and enabled by the wireless service carrier. ○ Press to answer an incoming call when another call is active. The original call is placed on ...