Wiper Blade Replacement

Windshield wiper blades should be inspected for wear or cracking. See Maintenance Schedule on page 11‑3 for more information on wiper blade inspection.

Replacement blades come in different types and are removed in different ways. To remove the wiper blade:

1. Pull the windshield wiper arm connector away from the windshield.

2. Squeeze the grooved areas on each side of the blade, and turn the blade assembly away from the arm connector.

2. Squeeze the grooved areas on each side of the blade, and turn the blade assembly away from the arm connector.

3. Install the new blade onto the arm connector and make sure the grooved areas are fully set in the locked position.

3. Install the new blade onto the arm connector and make sure the grooved areas are fully set in the locked position.

For the proper type and size, see Maintenance Replacement Parts on page 11‑15.

    See also:

    Power Seat Adjustment
    To adjust a power seat, if equipped: • Move the seat forward or rearward by sliding the control forward or rearward. • If available, raise or lower the front or rear part of the seat cushion b ...

    Charging System Light
    The charging system light comes on briefly when the ignition is turned on, but the engine is not running, as a check to show the light is working. It should go out when the engine is started. If t ...

    Windshield Wiper/Washer
    The windshield wiper/washer lever is located on the right side of the steering column. With the ignition in ACC/ACCESSORY or ON/RUN/ START, move the windshield wiper lever to select the wiper sp ...