Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID LOW ADD FLUID message displays, washer fluid will need to be added to the windshield washer fluid reservoir.
Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview on page 10‑6 for reservoir location.
Notice
• When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
• Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
Also, water does not clean as well as washer fluid.
• Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
• Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
See also:
Power Steering Fluid (3.0L V6 Engine)
The power steering fluid reservoir is located toward the rear of the engine compartment
on the passenger side of the vehicle. See Engine Compartment Overview on page 10‑6
for reservoir loc ...
Jump Starting
For more information about the vehicle battery, see Battery on page 10‑31.
If the vehicle is a hybrid, see the hybrid supplement for more information.
If the vehicle's battery (or batteries) h ...
Lockout Protection
If the driver side power door lock switch is pressed when the driver door is open and the key is in the ignition, all of the doors will lock and then the driver door will unlock.
If the passenger sid ...