Connecting a USB Storage Device or iPod®
The USB port can be used to control an iPod or a USB storage device.
To connect a USB storage device, connect the device to the USB port located in the center console or on the instrument panel.
To connect an iPod, connect one end of the USB cable that came with the iPod to the iPod’s dock connector and connect the other end to the USB port located in the center console or on the instrument panel. If the vehicle is on and the USB connection works, “OK to disconnect” and a GM logo may appear on the iPod, and iPod appears on the radio display. The iPod music appears on the radio’s display and begins playing.
The iPod charges while it is connected to the vehicle if the vehicle is in the ACC/ACCESSORY or ON/RUN position. When the vehicle is turned off, the iPod automatically powers off and will not charge or draw power from the vehicle's battery.
If you have an older iPod model that is not supported, it can still be used by connecting it to the auxiliary input jack using a standard 3.5 mm (1/8 in) stereo cable. See “Using the Auxiliary Input Jack” earlier for more information.
See also:
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.
See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...
The Inside
Here's where GM has really outdone itself in its new SUVs. Like the Tahoe,
the Yukon shows off one of the best interiors GM has ever mustered in a
mass-marketed vehicle. All the buttons are of abo ...
If the Vehicle Is Stuck
Slowly and cautiously spin the wheels to free the vehicle when stuck in sand, mud, ice, or snow.
See “Rocking Your Vehicle to Get It Out” later in this section.
If the vehicle has a traction sys ...