Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)

GMC Sierra / GMC Sierra Owners Manuals / Infotainment System / Introduction / Operation / Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)

BAL/FADE (Balance/Fade): To adjust the balance or fade:

1. Press the 2. Highlight the desired speaker control tab by doing one of the following: knob until the speaker control tabs display.

2. Highlight the desired speaker control tab by doing one of the following:

• Press the • Press the softkey under the desired tab. knob.

• Press the softkey under the desired tab.

3. Adjust the setting by doing one of the following:

• Turn the • Press the SEEK, or SEEK. knob clockwise or counterclockwise.

• Press the • Press the FWD, or REV. SEEK, or • Press the FWD, or REV. SEEK.

• Press the To quickly adjust all speaker and tone controls to the middle position, press the knob for more than two seconds. FWD, or To quickly adjust all speaker and tone controls to the middle position, press the knob for more than two seconds. REV.

To quickly adjust all speaker and tone controls to the middle position, press the If the Rear Seat Audio (RSA) is turned on, the radio disables FADE and mutes the rear speakers. knob for more than two seconds.

If the Rear Seat Audio (RSA) is turned on, the radio disables FADE and mutes the rear speakers.

    See also:

    Overview
    GMC unveiled the all-new 2007 Yukon and Yukon Denali full-size SUVs Oct. 5. They are based on GM's all-new full-size SUV family, which features distinctive styling, spacious and refined interiors, ...

    Bluetooth
    For vehicles equipped with Bluetooth capability, the system can interact with many cell phones, allowing: • Placement and receipt of calls in a hands-free mode. • Sharing of the cell phone’s a ...

    Replacing the Engine Air Cleaner/ Filter
    1. Locate the air cleaner/filter assembly. See Engine Compartment Overview on page 10‑6. 2. Loosen the four screws on the cover of the housing and lift up the cover. 3. Remove the engine a ...