Safety Belt Care
Keep belts clean and dry.
WARNING
Do not bleach or dye safety belts.
It may severely weaken them. In a crash, they might not be able to provide adequate protection.
Clean safety belts only with mild soap and lukewarm water.
See also:
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate trim.
2. Turn and pull the license plate lamp forward through the liftgate trim open ...
Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the vehicle must be on level ground. The engine oil dipstick handle is a yellow loop. See Engine ...
Increasing Speed While Using Cruise Control
If the cruise control system is already activated:
• Press and hold the +RES button on the steering wheel until the desired speed is reached, then release it.
• To increase vehicle speed in smal ...