Turning the System On and Off
The system can be disabled through the Driver Information Center (DIC).
See “Park Assist” under Vehicle Personalization (With DIC Buttons) on page 5‑46 for more information.
URPA defaults to the on setting each time the vehicle is started.
See also:
Using the “Digit Dial” Command
The digit dial command allows a phone number to be dialed by entering the digits one at a time.
After each digit is entered, the system repeats back the digit it heard followed by a tone.
If an unwa ...
Using Voice Commands During a Planned Route
Cancel Route
1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.”
System responds: “Would you like to cancel route directions to your destination?”
2. Say “Ye ...
Remote Vehicle Start
With this feature the engine can be started from outside of the vehicle. ...