Using the “Digit Dial” Command
The digit dial command allows a phone number to be dialed by entering the digits one at a time.
After each digit is entered, the system repeats back the digit it heard followed by a tone.
If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.
To hear all of the numbers recognized by the system, say “Verify” at any time.
1. Press and hold 
for two seconds.
2. Say “Digit Dial.” 3. Say each digit, one at a time, that you want to dial. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say “Dial.” Once connected, the person called will be heard through the audio speakers.
Using the “Re-dial” Command
1. Press and hold for two seconds.
2. After the tone, say “Re-dial.” Once connected, the person called will be heard through the audio speakers.
See also:
Driving on Hills
Driving safely on hills requires good judgment and an understanding of what the
vehicle can and cannot do.
WARNING
Many hills are simply too steep for any vehicle. Driving up hills can cause the
...
Fuel Additives
To provide cleaner air, all gasolines in the United States are now required to contain additives that help prevent engine and fuel system deposits from forming, allowing the emission control system to ...
Other ITBC-Related DIC Messages
In addition to displaying TRAILER GAIN and TRAILER OUTPUT through the DIC, trailer connection and ITBC system status are displayed on the DIC.
TRAILER CONNECTED: This message will be briefly displaye ...