Finding a Category (CAT) Station
CAT (Category): The CAT button is used to find XM stations when the radio is in the XM mode.
To find XM channels within a desired category:
1. Press BAND until the XM frequency displays.
2. Press CAT to display the category tabs.
3. Continue pressing CAT until the desired category name displays.
• Radios with CD and DVD can also navigate the category list by pressing
REV or
FWD.
4. Press either of the two buttons below the desired category tab to immediately tune to the first XM station associated with that category.
5. To go to the next or previous XM station within the selected category, do one of the following:
• Turn
.
• Press the buttons below the right or left arrows on the display.
• Press either SEEK arrow.
6. To exit the category search mode, press the FAV button or BAND button to display the favorites again.
Undesired XM categories can be removed through the setup menu.
To remove an undesired category, perform the following:
1. Press MENU to display the radio setup menu.
2. Press the softkey below the XM CAT tab.
3. Turn
to display the category to be removed.
4. Press the softkey under the Remove tab until the category name along with the word Removed displays.
5. Repeat the steps to remove more categories.
Removed categories can be restored by pressing the softkey under the Add tab when a removed category is displayed or by pressing the softkey under the Restore All tab.
Categories cannot be removed or added while the vehicle is moving faster than 8 km/h (5 mph).
See also:
Tips and Troubleshooting Chart
Problem
Recommended Action
There is no power.
The ignition might not be turned to ON/RUN or ACC/ACCESSORY.
The picture does not fill the screen. There are black bord ...
Remote Control
To use the remote control, aim it at the transmitter window at the rear of the overhead console and press the desired button. Direct sunlight or very bright light could affect the ability of the RSE ...
Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
If the headlamps are off or in the low-beam position, pull the turn signal lever toward you to momentarily switch to high be ...





