Finding a Station

BAND: Press to switch between AM, FM, or XM. The selection displays.

SEEK and (Tune): Turn to select radio stations.

SEEK: Press to go to the previous or next station and stay there. SEEK and SEEK: Press to go to the previous or next station and stay there. SEEK: Press to go to the previous or next station and stay there.

To scan stations, press and hold until a beep sounds. or until a beep sounds. until a beep sounds.

The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again to stop scanning.

The radio only seeks and scans stations with a strong signal that are in the selected band.

    See also:

    Programming Universal Home Remote — Fixed Code
    For questions or help programming the Universal Home Remote System, call 1-866-572-2728 or go to www.learcar2u.com. Most garage door openers sold before 1996 are Fixed Code units. Programming a gara ...

    Safety Belt Extender
    If the vehicle's safety belt will fasten around you, you should use it. But if a safety belt is not long enough, your dealer will order you an extender. When you go in to order it, take the heaviest ...

    Reading Lamps
    Press the button near each lamp to turn them on or off. For more information, see: • Dome Lamps on page 6‑5. • Instrument Panel Illumination Control on page 6‑5. ...