Engine Power Messages

ENGINE POWER IS REDUCED

This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode.

See Engine Overheating on page 10‑18 for further information.

This message also displays when the vehicle's engine power is reduced. Reduced engine power can affect the vehicle's ability to accelerate. If this message is on, but there is no reduction in performance, proceed to your destination. The performance may be reduced the next time the vehicle is driven. The vehicle may be driven at a reduced speed while this message is on, but acceleration and speed may be reduced. Anytime this message stays on, the vehicle should be taken to your dealer for service as soon as possible.

    See also:

    Stop/Tail/Turn Signal/ Sidemarker Lamp
    To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the two screw covers from the taillamp assembly. 3. Remove the two screws securing the taillamp asse ...

    Removing and Replacing the Floor Mat
    The driver side floor mat is held in place by two retainers. 1. Pull up on the rear of the floor mat to unlock each retainer and remove. 2. Reinstall by lining up the floor mat retainer openings o ...

    Leaving After Parking on a Hill
    1. Apply and hold the brake pedal while you: 1.1. Start the engine. 1.2. Shift into a gear. 1.3. Release the parking brake. 2. Let up on the brake pedal. 3. Drive slowly until the trailer is clea ...