Door Ajar Messages
DRIVER DOOR OPEN
This message displays and a chime sounds if the driver door is not fully closed and the vehicle is shifted out of P (Park). Stop and turn off the vehicle, check the door for obstructions, and close the door again. Check to see if the message still appears on the DIC.
HOOD OPEN
On some models, this message displays and a chime sounds if the hood is not fully closed. Stop and turn off the vehicle, check the hood for obstructions, and close the hood again. Check to see if the message still appears on the DIC.
LEFT REAR DOOR OPEN
This message displays and a chime sounds if the driver side rear door is not fully closed and the vehicle is shifted out of P (Park).
Stop and turn off the vehicle, check the door for obstructions, and close the door again. Check to see if the message still appears on the DIC.
LIFTGATE OPEN
This message displays and a chime sounds if the liftgate is open while the ignition is in ON/RUN. Turn off the vehicle and check the liftgate.
Restart the vehicle and check for the message on the DIC display.
PASSENGER DOOR OPEN
This message displays and a chime sounds if the passenger door is not fully closed and the vehicle is shifted out of P (Park). Stop and turn off the vehicle, check the door for obstructions, and close the door again. Check to see if the message still appears on the DIC.
POWER LIFTGATE OFF
This message displays when the power liftgate has been turned off by pressing the power liftgate button on the center console.
RIGHT REAR DOOR OPEN
This message displays and a chime sounds if the passenger side rear door is not fully closed and the vehicle is shifted out of P (Park).
Stop and turn off the vehicle, check the door for obstructions, and close the door again. Check to see if the message still appears on the DIC.
See also:
Fuel
Use of the recommended fuel is an important part of the proper maintenance of
this vehicle. To help keep the engine clean and maintain optimum vehicle performance,
we recommend the use of gasoline ...
Grade Braking (6-Speed Automatic Transmission)
The Grade Braking shift modes can be activated by pressing the button on the end of the shift control lever.
While in Range Selection Mode, Grade Braking is deactivated allowing the driver to select ...
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...





