Testing the Alarm

To test the alarm:

1. From inside the vehicle, lower the driver side window, and open the driver door.

2. Press 3. Get out of the vehicle, close the door, and wait for the security light to go out..

3. Get out of the vehicle, close the door, and wait for the security light to go out.

4. Reach in through the window, unlock the door with the manual door lock, and open the door.

This should set off the alarm.

If the alarm does not sound when it should, but the headlamps flash, check to see if the horn works.

The horn fuse may be blown.

To replace the fuse, see Fuses and Circuit Breakers on page 10‑31.

If the alarm does not sound or the headlamps do not flash, see your dealer for service.

    See also:

    DIC Buttons
    The buttons are the set/reset, customization, vehicle information, and trip/fuel buttons. The button functions are detailed in the following pages. (Set/Reset): Press this button to set or reset c ...

    Headlamp High/Low-Beam Changer
    Headlamp High/Low&-Beam Changer: Push the turn signal/lane change lever away from you and release, to turn the high beams on. To return to low beams, push the lever again or pull it toward yo ...

    Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)
    BAL/FADE (Balance/Fade): To adjust the balance or fade: 1. Press the knob until the speaker control tabs display. 2. Highlight the desired speaker control tab by doing one of the following: • Pr ...