Back–Up Lamp

Removal of the lamp assembly is not required to replace the back-up lamp bulb.

To replace one of these lamps:

1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim access panel.

3. Turn the bulb socket counterclockwise and pull it out.

3. Turn the bulb socket counterclockwise and pull it out.
4. Pull the bulb straight out of the socket.
5. Install the new bulb.
6. Push the bulb socket in and turn it clockwise.
7. Reinstall the interior trim access panel.

    See also:

    Exterior Lamp Controls
    The exterior lamp control is on the turn signal/lane change lever. (Exterior Lamp Control): Operates the exterior lamps. Turn to one of the following positions: (Off): Briefly turn to this pos ...

    Canceling a Remote Start
    To cancel a remote start, do one of the following: ○ Press until the parking lamps turn off. ○ Turn on the hazard warning flashers. ○ Insert the key and turn it to ON/ RUN and ...

    Power Windows
    Crew Cab Shown If available, the power window switches are located on each door. The driver door also has a switch for the passenger and rear windows. Push the switch to lower the window. Pull ...