Park Brake and P (Park) Mechanism Check
WARNING
When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.
○ To check the parking brake's holding ability: With the engine running and the
transmission in N (Neutral), slowly remove foot pressure from the regular brake
pedal. Do this until the vehicle is held by the parking brake only.
○ To check the P (Park) mechanism's holding ability: With the engine running, shift
to P (Park). Then release the parking brake followed by the regular brake.
Contact your dealer if service is required.
See also:
Hitches
It is important to have the correct hitch equipment. Crosswinds, large trucks going by, and rough roads are a few reasons why the right hitch is needed.
• The rear bumper on the vehicle is not inte ...
Driver Information Center (DIC) (Without DIC Buttons)
If your vehicle does not have DIC buttons, the information below explains the operation of this system.
The DIC has different displays which can be accessed by pressing the trip odometer reset stem l ...
Security Light
The security light should come on briefly as the engine is started.
If the system is working normally, the indicator light turns off. If it does not come on, have the vehicle serviced by your deale ...