Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) system makes the low-beam headlamps come on at a reduced brightness in daylight when the following conditions are met:
○ The ignition is on.
○ The exterior lamp band is in the automatic position.
○ The transmission is not in P (Park).
○ The light sensor determines it is daytime.
○ The parking brake is released. Fully functional Daytime Running Lamps (DRL) are
required on all vehicles first sold in Canada.
When the DRL are on the taillamps, sidemarker, instrument panel lights and other lamps will not be on. The instrument panel cluster will be lit. When the exterior lamp band is turned to the headlamp position, the low-beam headlamps come on. The other lamps that come on with the headlamps will also come on. To idle your vehicle with the DRL off, move the shift lever to P (Park). The DRL will stay off until the shift lever is moved out of the P (Park) position.
The regular headlamp system should be turned on when needed.
See also:
Ignition Positions
The ignition switch has four different positions.
To shift out of P (Park), the ignition must be in ON/RUN or ACC/ ACCESSORY and the regular brake pedal must be applied.
A (STOPPING THE ENGINE/ LO ...
Electronic Range Select (ERS) Mode
ERS or manual mode allows for the selection of the range of gear positions. Use
this mode when driving downhill or towing a trailer to limit the top gear and vehicle
speed. The shift position indi ...
Dome Lamps
There are front and rear dome lamps.
The dome lamp controls are located in the overhead console. To change the settings,
press the following:
(Dome Lamp Override): Turns the
lamps off, even whe ...





