Starting the Engine Using Remote Start

To start the engine using the remote start feature:

1. Press and release transmitter. on the RKE transmitter.

2. Press and hold seconds. The turn signal lamps will briefly flash to confirm the vehicle has been for about two seconds. The turn signal lamps will briefly flash to confirm the vehicle has been started. The parking lamps will turn on and remain on as long as the engine is running. The vehicle's doors will be locked.

3. The key must be inserted and turned to ON/RUN before driving.

The engine will shut off after 10 minutes unless a time extension is done or the key is inserted and turned to ON/RUN.

    See also:

    If a Tire Goes Flat
    It is unusual for a tire to blow out while driving, especially if the tires are maintained properly. If air goes out of a tire, it is much more likely to leak out slowly. But if there ever is a bl ...

    Oil Pressure
    This display shows the oil pressure in either kilopascals (kPa) or pounds per square inch (psi). ...

    Hood
    To open the hood: 1. Pull the release handle located below the instrument panel to the left of the steering wheel. 2. Move the secondary hood release lever to the right to release the striker. ...