Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

To replace one of these bulbs:

1. Open the tailgate. See Tailgate on page 2‑10 for more information.

2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull rearward until disengaging the two outer pins on the taillamp assembly from the vehicle.

2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull rearward until disengaging the two outer pins on the taillamp assembly from the vehicle.

B. Back-up Lamp A. Stoplamp/Taillamp/Turn Signal Lamp
B. Back-up Lamp

3. Turn the bulb socket counterclockwise to remove it from the taillamp assembly.

4. Pull the old bulb straight out from the socket.

5. Press a new bulb into the socket and turn the socket clockwise into the taillamp assembly.

6. Reinstall the taillamp assembly.

    See also:

    Tips and Troubleshooting Chart
    Problem Recommended Action There is no power. The ignition might not be turned to ON/RUN or ACC/ ACCESSORY. The picture does not fill the screen. There are black bor ...

    Engine Coolant Heater
    The engine heater can provide easier starting and better fuel economy during engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with an engine heater should be plugged ...

    Multi-Band Antenna
    The multi-band antenna is on the roof of the vehicle. The antenna is used for the AM&-FM radio, OnStar, the XM Satellite Radio Service System, and GPS (Global Positioning System), if the vehic ...