Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID LOW ADD FLUID message displays, washer fluid will need to be added to the windshield washer fluid reservoir.
Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview on page 10‑6 for reservoir location.
Notice
• When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
• Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
Also, water does not clean as well as washer fluid.
• Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
• Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
See also:
Flash-to-Pass
The flash&-to&-pass feature works with the low beams or Daytime Running Lamps
(DRL) on or off.
To flash the high beams, pull the turn signal/lane change lever all the way toward
you, then ...
Stopping and Resuming Playback
To stop playing a DVD without turning off the system, do one of the following:
• Press on the remote control.
• Press the softkey under the stop or the play/pause icons displayed on the radio.
...
Programming Transmitters to the Vehicle
Only RKE transmitters programmed to this vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer.
When the replacement transmitter is ...