Grade Braking (6-Speed Automatic Transmission)
The Grade Braking shift modes can be activated by pressing the button on the end of the shift control lever.
While in Range Selection Mode, Grade Braking is deactivated allowing the driver to select a desired range of gears.
Grade Braking is only active while the Tow/Haul Mode is selected and you are not in the Range Selection Mode. See “Tow/Haul Mode” listed previously and Manual Mode on page 9‑41 for more information on the Range Selection Mode. Grade Braking assists in maintaining desired vehicle speeds when driving on downhill grades by automatically implementing a shift schedule that utilizes the engine and transmission to slow the vehicle. This reduces wear on the braking system and increases control of the vehicle.
Grade Braking monitors vehicle speed, acceleration, engine torque and brake pedal usage. Using this information, it detects when the truck is on a downhill grade and the driver desires to slow the vehicle by pressing the brake.
This feature is active when the exhaust brake is enabled (if equipped).
Also see Towing Equipment on page 9‑100 for more information.
See also:
New for 2012
The Canyon sees only some minor changes for 2012. A Bodyguard Package
provides bed rail covers and molded splash guards, and an available Chrome
Accessory Package includes a chrome exhaust tip and ...
Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the storage compartment on the driver side, at the rear of the vehicle.
1. Press down on the latch tab and pull the cover off to access the storage ...
Add-On Electrical Equipment
Notice: Do not add anything electrical to the vehicle unless you check with your
dealer first. Some electrical equipment can damage the vehicle and the damage would
not be covered by the vehicle ...





