Fast Idle System
If the vehicle has this feature it is available only with cruise control.
The manual fast idle switch is operated using the cruise control buttons located on the left hand side of the steering wheel.
This system can be used to increase engine idle speed whenever the following conditions are met:
• The park brake is set.
• The brake pedal is not pressed.
• The vehicle must not be moving and the accelerator must not be pressed.
To control the fast idle:
• To enable the Fast Idle System, press and release the Cruise Control On/Off button and ensure that the switch LED is lit.
• Press and release the Cruise Control Set switch. Engine speed will be held at approximately 1200 RPM.
When the fast idle is active the Driver Information Center (DIC) will display “FAST IDLE ON.” One of the following actions will turn off the fast idle:
• Pressing the brake.
• Selecting the Cruise Control Cancel button.
• Releasing the Parking Brake.
• The transmission shift lever is moved out of P (Park) or N (Neutral).
• Selecting the Cruise Control On/ Off button when it was previously on.
• Pressing the Cruise Control Set switch a second time.
• Pressing the accelerator greater than a quarter of the down.
• Turning the ignition switch to the LOCK/OFF position.
See also:
Battery Voltage and Charging Messages
BATTERY LOW START VEHICLE
When the vehicle’s battery is severely discharged, this message will display and four chimes will sound. Start the vehicle immediately. If the vehicle is not started and t ...
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning fl ...
Antilock Brake System (ABS)
This vehicle has the Antilock Brake System (ABS), an advanced electronic braking
system that helps prevent a braking skid.
When the engine is started and the vehicle begins to drive away, ABS check ...