Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)

GMC Sierra / GMC Sierra Owners Manuals / Infotainment System / Introduction / Operation / Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)

BAL/FADE (Balance/Fade): To adjust the balance or fade:

1. Press the 2. Highlight the desired speaker control tab by doing one of the following: knob until the speaker control tabs display.

2. Highlight the desired speaker control tab by doing one of the following:

• Press the • Press the softkey under the desired tab. knob.

• Press the softkey under the desired tab.

3. Adjust the setting by doing one of the following:

• Turn the • Press the SEEK, or SEEK. knob clockwise or counterclockwise.

• Press the • Press the FWD, or REV. SEEK, or • Press the FWD, or REV. SEEK.

• Press the To quickly adjust all speaker and tone controls to the middle position, press the knob for more than two seconds. FWD, or To quickly adjust all speaker and tone controls to the middle position, press the knob for more than two seconds. REV.

To quickly adjust all speaker and tone controls to the middle position, press the If the Rear Seat Audio (RSA) is turned on, the radio disables FADE and mutes the rear speakers. knob for more than two seconds.

If the Rear Seat Audio (RSA) is turned on, the radio disables FADE and mutes the rear speakers.

    See also:

    Tailgate Removal
    The tailgate can be removed to allow for different loading situations. Assistance may be needed with the removal to avoid damage to the vehicle. On vehicles with a Rear Vision Camera, it must be dis ...

    Shoulder Belt Height Adjuster
    The vehicle has a shoulder belt height adjuster for the driver and right front passenger. Adjust the height so the shoulder portion of the belt is on the shoulder and not falling off of it. The belt ...

    Engine Hours
    To display the ENGINE HOURS, place the ignition in LOCK/OFF or ACC/ACCESSORY, then press and hold the trip odometer reset stem for four seconds while viewing the ODOMETER. This display shows the total ...