Storing the Tools

A. Tool Bag
A. Tool Bag
B. Wing Bolt
C. Jack

Put back all tools as they were stored in the jack storage compartment and put the compartment cover back on.

1. Ensure that the bottom of the jack is facing toward you.

2. Replace the tool bag (A).

3. Turn the jack (C) on its side and place down on the holding bracket.

4. Reinstall the wing bolt (B) by turning clockwise.

5. To replace the cover, line up the tab at the front of the cover with the notch in the cover opening.

Push the cover in place and make sure that the rear clips are in the slots and push the cover closed.

Store the center cap or the plastic bolt-on wheel covers until a full size tire is put back on the vehicle.

When you replace the compact spare with a full-size tire, reinstall the bolt-on wheel covers or the center cap. Hand-tighten them over the wheel nuts, using the wrench.

    See also:

    Unable to Connect to OnStar Message
    If there is limited cellular coverage or the cellular network has reached maximum capacity, this message may come on. Push to try the call again or try again after driving a few miles into another ce ...

    If No Steam Is Coming from the Engine Compartment
    If an engine overheat warning is displayed but no steam can be seen or heard, the problem may not be too serious. Sometimes the engine can get a little too hot when the vehicle: • Climbs a long hil ...

    Driver Information Center (DIC)
    The DIC display is located at the bottom of the instrument panel cluster. It shows the status of many vehicle systems and enables access to the personalization menu. The DIC buttons are located on ...