Storing the Flat Tire

1. Remove the cable package from the jack storage area.

2. Remove the small center cap by tapping the back of the cap with the extension of the shaft, if the vehicle has aluminum wheels.

3. Put the flat tire in the rear storage area with the valve stem pointing toward the rear of the vehicle.

A. Cable
A. Cable
B. Liftgate Hinges
C. Spare Tire Heat Shield
D. Center of the Wheel
E. Door Striker

4. Pull the cable (A) through the door striker (E), the center of the wheel (D), and the plastic spare tire heat shield (C), as shown.

5. Hook the cable onto the outside portion of the liftgate hinges (B).

5. Hook the cable onto the outside portion of the liftgate hinges (B).

6. Hook the other end of the cable onto the outside portion of the liftgate hinge on the other side of the vehicle.

7. Pull on the cable to make sure it is secure.

8. Make sure the metal tube is centered at the striker. Push the tube toward the front of the vehicle.

8. Make sure the metal tube is centered at the striker. Push the tube toward the front of the vehicle.

9. Close the liftgate and make sure it is latched properly.

    See also:

    Driving on Wet Roads
    Rain and wet roads can reduce vehicle traction and affect your ability to stop and accelerate. Always drive slower in these types of driving conditions and avoid driving through large puddles and dee ...

    Cigarette Lighter
    To use the cigarette lighter, push it in all the way, and let go. When it is ready for use, the lighter pops back out. Notice: Holding a cigarette lighter in while it is heating does not let the ligh ...

    Reducing Speed While Using Cruise Control
    If the cruise control system is already activated, . Press and hold the SET– button on the steering wheel until the desired lower speed is reached, then release it. • To slow down in small amount ...