Trailer Wiring Harness
Basic Trailer Wiring
The trailer wiring harness, with a seven-pin connector, is located at the rear of the vehicle and is tied to the vehicle's frame. The harness connector can be plugged into a seven-pin universal heavy-duty trailer connector available through your dealer.
The seven-wire harness contains the following trailer circuits:
• Yellow: Left Stop/Turn Signal
• Dark Green: Right Stop/Turn Signal
• Brown: Taillamps
• Black: Ground
• Light Green: Back-up Lamps
• Red/Black: Battery Feed
• Dark Blue: Trailer Brake*
*The fuse for this circuit is installed in the underhood electrical center, but the wires are not connected.
They should be connected by your dealer or a qualified service center.
If the back-up lamp circuit is not functional, contact your dealer.
If a remote (non-vehicle) battery is being charged, press the Tow/Haul mode switch located on the center console near the climate controls.
This will boost the vehicle system voltage and properly charge the battery. If the trailer is too light for Tow/Haul mode, turn on the headlamps (non-HID only) as a second way to boost the vehicle system and charge the battery.
See also:
GMC Terrain in the Market
With the Equinox and Terrain, GM stands to regain some lost share in the
crossover market — if for no other reason than 32 mpg in an SUV is no small
feat. The Terrain is competitive otherwise, b ...
Turning the System On and Off
The URPA system can be turned on and off using the infotainment system controls.
See Vehicle Personalization on page 5‑33 for more information.
When the system is off, PARK ASSIST OFF display ...
Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it.
But if a safety belt is not long enough, your dealer will order you an extender. When you go in to order it, take the heaviest ...